|
|
| Cosmetic covers |
 |
Cosmetic
covers are designed for the load-bearing unit of lower-limb
prostheses.
Material - elastic fine-cellular polyurethane with antistatic
properties.
The cosmetic covers are delivered in the following forms:
- for trans-femoral residual limb prostheses in the form of a rough part, with the preliminary form of a prosthetic limb. When a cosmetic covering is ordered the scheme of measurement and the table for determining the optimal linear and volumetric sizes should be used. (The scheme of measurement and the table are shown in RSC ENERGIA "Low-limb prosthetics" catalogue, "Covers" section).
- for trans-tibial residual limb prostheses in the form of a rough part without the longitudinal hole (sizes: height - 170 mm, width - 170 mm, length - 500 mm)
- for trans-tibial residual limb prostheses in the form of a rough part with the longitudinal hole (sizes: height - 170 mm, width - 170 mm, length - 500 mm)
- for trans-tibial residual limb prostheses and trans-femoral residual limb prostheses in the form of blocks and sheets. The sizes are listed in RSC ENERGIA "Low-limb prosthetics" catalogue, "Covers".
|
|
|
|
